P4DEBUG

Description

Usage Notes

Used by Perforce Client?	Used by Perforce Server	Command-Line Alternative	Can be set in P4CONFIG file?
No	Yes	None	No

Value if not Explicitly Set

Operating System	Value
All	If not set, this variable is not used.

Examples

server=1

Notes

The preferred way to set trace flags for the Perforce server is to set them on the p4d command line. For technical reasons, this does not work for sites running Perforce as a service under NT. Administrators at such sites can use p4 set to set the trace flags within P4DEBUG, allowing the NT service to run with the flags enabled.

For further information, see the System Administrator's Guide.