p4 monitor

Synopsis

Syntax

Description

p4 monitor allows a system administrator to observe what Perforce-related processes are running on the Perforce server machine. Each line of output consists of the following fields:

pid status owner hh:mm:ss command [args]

To list current process information, use p4 monitor show. All processes are listed, but only the command (for example, sync, edit, submit) is shown, without arguments. This form of p4 monitor requires list level access.

To show the list of arguments associated with each command, use the -a (arguments) flag or -l (long) flag. For additional information from the user environment, use the -e (environment) flag. These options require admin level access.

To mark a process for termination, use p4 monitor terminate id. This command requires admin level access.

To remove an entry from the monitor table, use p4 monitor clear id. You can clear the entire table with p4 monitor clear all. Both of these forms require admin level access.

Options

g-opts	See the Global Options section.
-a	Show all arguments associated with the process (for example, edit file.c, or sync -f //depot/src/...). Perforce user names are truncated to 10 characters, and each line is limited to a total of 80 characters of output.
-e	Show environment information including Perforce client application (if known), host IP address, and client workspace name.
-l	Show all arguments in long form; that is, without truncating user names or the list of command line arguments.

Usage Notes

Can File Arguments Use Revision Specifier?	Can File Arguments Use Revision Range?	Minimal Access Level Required
No	No	list, admin

• Processes marked as running continue to run to completion even if removed from the monitor table with p4 monitor clear.

• If a command terminates prematurely on the server side, it may be erroneously listed as running. You can clear such processes with p4 monitor clear.

• The p4 monitor terminate command will not mark a process for termination unless the process has already been running for at least ten seconds.

• Some commands (for instance, p4 submit) invoke multiple processes. For example, dm_CommitSubmit or dm_SubmitChange may appear in the output of p4 monitor as two separate phases of the p4 submit command.

• Some commands, such as p4 obliterate, cannot be terminated.

Examples

p4 monitor show	Show Perforce processes information (commands only). Requires list access only.
p4 monitor show -l	Show arguments and commands, without limits on line length. Requires admin access.
p4 monitor show -a	Show arguments and commands, limited to 80 characters per line of output. Requires admin access.
p4 monitor terminate 123	Instruct the Perforce server to mark process 123 for termination. Requires admin access.
p4 monitor clear all	Clears the monitor table of all entries. Requires admin access.

Related Commands

To turn on server monitoring (requires server restart)	p4 counter -f monitor 1
To turn off server monitoring (requires server restart)	p4 counter -f monitor 0