Perforce 2008.1 Command Reference
<< Previous Chapter
Environment and Registry Variables
 Table of Contents
Index
Perforce on the Web
 Next Chapter >>
P4CHARSET

P4AUDIT

Description

Location of the server audit log file.

Usage Notes

Used by
Client?
 Used by
Server?
 Command-Line Alternative
 Can be set in P4CONFIG file?

Yes

No

p4d -A auditlog

N/A

Value if not Explicitly Set

Operating System
 Value

All

None. If no log file is specified, auditing is disabled.

Notes

P4AUDIT specifies the location of the audit log file.

When auditing is enabled, the server adds a line to the audit log file every time file content is transferred from the server to the client. On an active server, the audit log file will grow very quickly.

Lines in the audit log appear in the form:

For example:

If a command is run on the machine that runs the Perforce Server, the clientIP is shown as 127.0.0.1.

For more information, see the System Administrator's Guide.

Perforce 2008.1 Command Reference
<< Previous Chapter
Environment and Registry Variables
 Table of Contents
Index
Perforce on the Web
 Next Chapter >>
P4CHARSET
Please send comments and questions about this manual to [email protected].
Copyright 1999-2008 Perforce Software. All rights reserved.
Last updated: 07/08/08